ASUS CUV4X MOTHERBOARD DRIVER DOWNLOAD

There is no possibility for connection of one more thermistor. Virtually identical results were also obtained after running other programs e. The ATX power supply connector is located near the upper edge of the board and it can be difficult to reach in some cases. Since SCSI connectors are located “in parallel” to the board, the connector’s cable can go either up or down. At first I thought the system wasn’t going to boot. That means when you turn the system on in the morning, it will be almost 20 seconds before you can tell that it has responded!

Uploader: Tygotaxe
Date Added: 3 August 2008
File Size: 58.3 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 63575
Price: Free* [*Free Regsitration Required]

The mottherboard users can enable the AGP 4X mode having adjusted the register: The ATX power supply connector is located near the upper edge of the board and it can be difficult to reach in some cases.

The layout is rather compact due to two sockets, SCSI and network controller. If you need an external COM 2, then you will need to install a back panel plate with a ribbon cable connection to the motherboard. I observed no glitches, and the system ran everything without hanging, or dropping to the desktop. I tried 2 other CUV4X motherboards, and got similar results.

  FUJITSU SIEMENS S7010 BLUETOOTH DRIVER

Asus CUV4X Motherboard Review –

Two SCSI channels act as separate controllers, they even use separate interrupt lines. Testing The test system cu4x It can be difficult ot explain just by a small difference in frequency of clock generators. Virtually identical results were also obtained after running other programs e. At this setting, the system was running at MHz, with a memory speed of MHz. Finally, I put a new Celeron flip-chip in the system, and tested for variation in the Norton benchmark.

ASUS CUV4X-E, Socket 370, Intel Motherboard

The initial setup included: The variability was still quite noticeable, as shown in the chart below. Pentium III overclock stability seemed better than Celeron-2 overclockability, but we did not motheeboard extra Celeron-2s around to test, so we can’t say for sure. The overall boot time was also longer than normal for a clean system. The system ran 3D Mark without a hitch.

The clock generator chip rises much more anxiety. The board features its own speaker, that’s why it’s not necessary to use case’s speaker.

cuv4d Unfortunately, at the time of this review, we only had 1 Celeron-2 chip available for testing, so I’m not sure if these results are typical. In the Windows driver properties it was specified that the disc would use DMA mode if it was available. The driver from VIA was installed. Still, MHz on the front side bus is very respectable.

  ASUS P5WDH DELUXE WIRELESS DRIVER

It’s a serious claim for the market of high-efficient PCs, work stations and entry-level servers.

ASUS CUV4X-E, Socket , Intel Motherboard | eBay

Besides, for two MHz systems we received quite low scores. All overclock testing was done with a core voltage setting of 1.

The results were mothreboard puzzling. A typical score after a clean reboot was Norton units. The second, an orange one, shows that the card is connected to the Mbit network. I tried higher and lower core voltages, but the system refused to boot. If you can put up with the slow boot times, the board will do a very good job of overclocking Pentium III processors.

After that we adjusted memory and CPU frequencies. The problems concerning soft support seem to be mostly related with VIA and I hope they will be solved in the nearest time. There is nothing to prevent an installation of processors and coolers. Overclocking with the Celeron-2 was rather disappointing.

Start the discussion

Leave a Reply

Your email address will not be published. Required fields are marked *